Kenwood NX-5200 User Manual page 21

Battery Status <Battry>
o
Allows you to view the battery power status. Battery status is represented by the
number of times the LED indicator flashes red. Four flashes represents full power,
three represents medium power, two represents low power, and one represents very
low power. If the LED flashes red only one time, recharge or replace your battery pack
immediately. When the Low Battery Warning function is active {p. 41} and the
battery power is low, this key will not operate.
If the Battery Level Tone has been enabled, a beep tone will sound according to the
number of flashes from the LED.
Bluetooth <Btooth>
o
Enables or disables the Bluetooth function. Refer to "Bluetooth" {p. 44} .
Bluetooth Device
o
Activates Bluetooth Device mode.
Bluetooth Speaker <BtSpkr>
o
Allows you to switch the speaker from the transceiver's built-in speaker to the speaker
of a connected Bluetooth device.
Bluetooth Connect/ Disconnect <BtConn/ BtDisc>
o
Press this key to pair with the selected Bluetooth device when a Bluetooth device is
not connected. When a Bluetooth device is connected, press this key to disconnect
the Bluetooth device.
Broadcast <B.Cast>
o
Allows you to make a Broadcast Group Call. Switches between Broadcast Group
Call and Conference Group Call when Broadcast Group Call is enabled.
Call 1 ~ 6 <Call1 ~ Call6>
o
Press this key to send a message or initiate a call.
Call Response <CalRes>
o
Press this key to respond to an Individual Call. When an Individual Call is received,
the Alert tone stops.
Channel Down <CH－>
o
Press this key to decrease the channel number. {p. 4}
Channel Entry <CH_Ent>
o
Press this key to enter Channel Entry Mode, to select a channel.
Channel Recall <CH_Rcl>
o
Press this key during Scan to return to the last called zone and channel.
21