Danfoss FP715 Si Installation & User's Instructions page 6
Electronic, 2-channel full
programmer for heating
& hot water with service
interval timer including 24v models
Hide thumbs
Also See for FP715 Si:
- User manual (24 pages) ,
- Installation manual (20 pages) ,
- User instructions (2 pages)
Table of Contents
Advertisement
Copy Functions Explained
There are 3 possible copy functions available. These are;
Standard Copy, Enhanced Copy, and AB copy. Copy functions
are enabled/disabled in the Advanced Programming Options
(page 5).
Standard Copy: Pressing copy will copy the previous days
events into the displayed day. The unit will then display the 1st
event for the new day. This copy function is present only if the
unit is set to run in 5+2 or 7 day mode.
Enhanced Copy: The enhanced copy function is available in 7
day mode only. This allows any day to be copied to any other
day, or days. To use the enhanced copy function go into the
event programming using the PROG button, then:
1.
Use the
2.
Press the
When selected, the day should begin to fl ash.
3.
Use the
4.
Press
5.
Repeat steps 3 and 4 to select and copy other days.
6.
To stop copying, use the
fl ashing day and press the COPY button. The previously
fl ashing day will stop fl ashing to indicate it has been de-
selected.
NOTE: When a day has been copied to, it will remain visible and
not fl ashing when the DAY button is used to select other days.
AB Copy: The AB copy function is available in 5+2 mode only
and only if activated in the Advanced Programming setting.
A and B days, when selected, can be any group of days e.g. 5+2,
4+3 etc. The days do not have to run in sequence. For example,
to operate in a 5+2 day mode the days can be set as follows:
6
DAY button to fi nd the day to be copied from.
COPY button to select the day to be copied from.
DAY button to fi nd the day to be copied to.
COPY button to copy the selected day.
DAY button to go back to the
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the FP715 Si and is the answer not in the manual?
Questions and answers
Heating not going off even though I’ve turned it off at the thermostat and controls??
The Danfoss FP715 Si heating may not be turning off despite being switched off at the thermostat and controls due to the following possible reasons:
1. Cylinder Thermostat Detection: If the hot water cylinder thermostat detects that the water temperature has not yet reached the set level, the heating system may continue to operate.
2. Programmed Mode: The programmer may be set to "ON" or "ALLDAY" mode, which keeps the heating running continuously. Ensure it is set to "AUTO" or "OFF" if you want it to turn off.
3. Temporary Override: The +1HR override button may have been pressed, causing the heating to stay on for an extra hour.
4. Service Interval Timer: If the property owner (e.g., a landlord) has enabled a service interval timer, it may affect the heating operation.
Check the programmer settings, override functions, and thermostat to confirm the correct configuration.
This answer is automatically generated