Accepting The Preset Programmes - Danfoss FP715 Si Installation & User's Instructions
Electronic, 2-channel full
programmer for heating
& hot water with service
interval timer including 24v models
Hide thumbs
Also See for FP715 Si:
- User manual (24 pages) ,
- Installation manual (20 pages) ,
- User instructions (2 pages)
Table of Contents
Advertisement
Press DAY/HOL to display day and
month. Use the + or - buttons to set
the correct month (Jan = 1, Feb = 2
etc.).
Press DAY/HOL to display day and
month. Use the + or - buttons to set
day of month.
Press PROG to display the time.
The words SET TIME will appear at
the top of the display & the time will
fl ash on and off .
Use the + or - buttons to set the
correct time (press and hold to
change in 10 min. increments).
Setting the Day
The day of the week is set automatically.
Accepting the preset programmes
If you are happy to use the preset
programmes on page 17, you don't
need to do anything else.
Press the PROG button once to return to run mode.
19
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the FP715 Si and is the answer not in the manual?
Questions and answers
Heating not going off even though I’ve turned it off at the thermostat and controls??
The Danfoss FP715 Si heating may not be turning off despite being switched off at the thermostat and controls due to the following possible reasons:
1. Cylinder Thermostat Detection: If the hot water cylinder thermostat detects that the water temperature has not yet reached the set level, the heating system may continue to operate.
2. Programmed Mode: The programmer may be set to "ON" or "ALLDAY" mode, which keeps the heating running continuously. Ensure it is set to "AUTO" or "OFF" if you want it to turn off.
3. Temporary Override: The +1HR override button may have been pressed, causing the heating to stay on for an extra hour.
4. Service Interval Timer: If the property owner (e.g., a landlord) has enabled a service interval timer, it may affect the heating operation.
Check the programmer settings, override functions, and thermostat to confirm the correct configuration.
This answer is automatically generated