Danfoss FP715 Si Installation & User's Instructions page 11
Electronic, 2-channel full
programmer for heating
& hot water with service
interval timer including 24v models
Hide thumbs
Also See for FP715 Si:
- User manual (24 pages) ,
- Installation manual (20 pages) ,
- User instructions (2 pages)
Table of Contents
Advertisement
Wires other
W
HTG
than links in
ON
these terms
go to LIVE
4
L
1
-
3
7
4
6
4
-
4
-
1
-
1
-
4
-
A/S
-
3
-
A/S
-
5
-
NOTE
This conversion applies
only if....
L
-
4
3
-
Programme
-
selectors UNLINKED
-
Programme
-
selectors UNLINKED
-
Used in a system having
-
independent control of
water and heating
-
-
-
An additional terminal
block may be required
where these discon-
nected leads (or pairs)
should be terminated
A
B
C
3
6
A
B
C
A/S
3
A/S
5
D
11
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the FP715 Si and is the answer not in the manual?
Questions and answers
Heating not going off even though I’ve turned it off at the thermostat and controls??
The Danfoss FP715 Si heating may not be turning off despite being switched off at the thermostat and controls due to the following possible reasons:
1. Cylinder Thermostat Detection: If the hot water cylinder thermostat detects that the water temperature has not yet reached the set level, the heating system may continue to operate.
2. Programmed Mode: The programmer may be set to "ON" or "ALLDAY" mode, which keeps the heating running continuously. Ensure it is set to "AUTO" or "OFF" if you want it to turn off.
3. Temporary Override: The +1HR override button may have been pressed, causing the heating to stay on for an extra hour.
4. Service Interval Timer: If the property owner (e.g., a landlord) has enabled a service interval timer, it may affect the heating operation.
Check the programmer settings, override functions, and thermostat to confirm the correct configuration.
This answer is automatically generated