Danfoss FP715 Si Installation & User's Instructions page 25

Electronic, 2-channel full programmer for heating & hot water with service interval timer including 24v models
Hide thumbs Also See for FP715 Si:
Table of Contents

Advertisement

Programming the heating in 24 hour mode
1.
Press PROG once until SET CH
ON TIME appears at the top of
the display.
Use the + OR - buttons to set
the time you want your heating
to fi rst come on in the morning
(Event 1).
2.
Press NEXT ON/OFF to move to
Event 2.
Continue
central heating ON and OFF
times by pressing:
a) NEXT ON/OFF button to
move to the next setting,
b) + OR - buttons to amend the
time.
3.
Press the PROG twice button
to return the unit to RUN mode
(time appears & colon in the
display begins to fl ash).
4.
Proceed to page 27.
programming
the
DAY/HOL
DAY/HOL
DAY/HOL
DAY/HOL
25

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FP715 Si and is the answer not in the manual?

Questions and answers

Claire Harwood
February 20, 2025

Heating not going off even though I’ve turned it off at the thermostat and controls??

User image 67b74d19bea98
1 comments:
Mr. Anderson
February 20, 2025

The Danfoss FP715 Si heating may not be turning off despite being switched off at the thermostat and controls due to the following possible reasons:

1. Cylinder Thermostat Detection: If the hot water cylinder thermostat detects that the water temperature has not yet reached the set level, the heating system may continue to operate.

2. Programmed Mode: The programmer may be set to "ON" or "ALLDAY" mode, which keeps the heating running continuously. Ensure it is set to "AUTO" or "OFF" if you want it to turn off.

3. Temporary Override: The +1HR override button may have been pressed, causing the heating to stay on for an extra hour.

4. Service Interval Timer: If the property owner (e.g., a landlord) has enabled a service interval timer, it may affect the heating operation.

Check the programmer settings, override functions, and thermostat to confirm the correct configuration.

This answer is automatically generated

Subscribe to Our Youtube Channel

Table of Contents

Save PDF