Danfoss FP715 Si Installation & User's Instructions page 23
Electronic, 2-channel full
programmer for heating
& hot water with service
interval timer including 24v models
Hide thumbs
Also See for FP715 Si:
- User manual (24 pages) ,
- Installation manual (20 pages) ,
- User instructions (2 pages)
Table of Contents
Advertisement
Programming the heating in 7 day mode
1.
Press PROG once until SET CH
ON TIME appears at the top of
the display. Note the current day
is displayed. Press the DAY/HOL
button until the required day is
displayed.
2.
Use the + OR - buttons to set
the time you want your heating
to fi rst come on in the morning
(Event 1).
3.
Press NEXT ON/OFF to move to
Event 2.
4.
Continue
central heating ON and OFF
times in this way by using the +
or - buttons to set the time you
want and pressing the NEXT
ON/OFF button to move to the
next setting.
5.
Press DAY/HOL button once
only. The next day will appear
at the bottom of the display.
Repeat steps 2-5.
programming
the
DAY/HOL
DAY/HOL
DAY/HOL
DAY/HOL
23
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the FP715 Si and is the answer not in the manual?
Questions and answers
Heating not going off even though I’ve turned it off at the thermostat and controls??
The Danfoss FP715 Si heating may not be turning off despite being switched off at the thermostat and controls due to the following possible reasons:
1. Cylinder Thermostat Detection: If the hot water cylinder thermostat detects that the water temperature has not yet reached the set level, the heating system may continue to operate.
2. Programmed Mode: The programmer may be set to "ON" or "ALLDAY" mode, which keeps the heating running continuously. Ensure it is set to "AUTO" or "OFF" if you want it to turn off.
3. Temporary Override: The +1HR override button may have been pressed, causing the heating to stay on for an extra hour.
4. Service Interval Timer: If the property owner (e.g., a landlord) has enabled a service interval timer, it may affect the heating operation.
Check the programmer settings, override functions, and thermostat to confirm the correct configuration.
This answer is automatically generated