Dimplex BLF3451 Owner's Manual page 16

Operation
the Floating Display
!
NOTE: The heater may emit
a slight, harmless odor when first
used. This odor is a normal condition
caused by initial heating of internal
heater parts and will not occur again.
D & E. Thermostat Controls
Adjusts the temperature set point
to your individual requirements.
Once the desired set temperature is
reached the heater will turn off. The
heater will cycle on and off to main-
tain the desired set temperature. The
default temperature setting is 72°F
(22°C).
→ Adjusted by pressing the
decrease the setpoint and the
to increase the setpoint on the unit
or the remote.
• The Floating Display
the temperature setpoint as it is
adjusted.
!
NOTE: Holding the
buttons down for two seconds,
on the unit, will change the tempera-
ture from °C to °F, or vice versa.
16
.
TM
to
will indicate
TM
and the
Disable Heat
If desired, depending on the sea-
son, the heater on the unit can be
disabled. The unit will operate in the
same fashion, with remainder of the
controls.
Pressing the
the unit at the same time and holding
for 2 seconds will disable and enable
the heater.
!
NOTE: When the heater has been
disabled and either the
is pressed the Floating Display
will indicate "--".
F. Color Themes
Different presets of ambient lighting
color combinations contained in the
unit.
→ Changed by repeatedly pressing
the corresponding button on the
remote or the unit.
• Cycles through the different preset
ambient lighting settings of the
unit, this includes different com-
binations of colours of the flame
base and media lighting.
!
NOTE: The last theme of the
cycle is a prism where the unit cycles
through a variety of colours. Pressing
the button stops the cycling and
holds the unit on the preferred color,
indicated by a "U" - Unfreeze or a "F"
- Freeze on the display.
and buttons on
or the
www.dimplex.com
TM