For Bathroom Use; Surface Mount Installation - Dimplex BLF3451 Owner's Manual

Fireplace Installation
Figure 5
Wall Mounting
Bracket
Bottom Support
Bracket

For Bathroom Use

If this unit is installed in a bathroom it
must be protected by a GFI recep-
tacle or circuit. If receptacle is used it
must be readily accessible.
To prevent electrical shock this unit
is an electrical appliance that is NOT
watertight and must be installed as to
prevent water from entering unit. This
must be installed away from show-
ers, tubs, etc. Never locate fireplace
where it may fall into a bathtub or
other water container.

Surface Mount Installation

CAUTION: Two people may be
required for various steps of this
procedure.
1. Choose your method of supplying
power to the unit:
• Plug in to an existing outlet or
10
Figure 6
install an outlet nearby.
• Hard wire the fireplace. Follow the
hard wiring instructions on page 8.
WARNING: Do not attempt to wire
your own new outlets or circuits. To
reduce the risk of fire, electric shock or
injury to persons, always use a licensed
electrician.
WARNING: Ensure that the
circuit on which the fireplace is to
be installed has the power cut off at
the service panel until installation is
complete.
2. Determine the mounting location
of the unit so that the wall mount-
ing bracket can be installed into 2
wall studs.
!
NOTE: It is recommended that the
mounting bracket be installed 56 in.
(142 cm) off of the ground to maintain
an optimized viewing angle of the
flame.
3. Hold the wall mounting bracket,
www.dimplex.com