Removing Your 2Touch Board From The Packaging; Choosing The Iwb Location - 2Touch 2150 series Installation Manual

Table of Contents

optics system requires training and experience and this subject is not included

in this Guide.

Installers wanting to become 2Touch Certified Installers are invited to apply

by email to installers@twotouch.com.

Removing your 2Touch Board from the packaging

The carton packaging comprises of an outer two-piece wrap plus top and

bottom trays. The board is supported within the trays by carton forms and

blocks. The wrap provides exterior protection during transport, as well as a

convenient hand-grip at each end of the package. The package is strapped

together in three locations along the length of the board, and stapled to the

trays.

Unpacking the board requires keeping the board supported by cutting the

straps, lifting the top tray off, removing the wraps and finally, lifting the unit

away from the lower tray.

Please check the package carefully prior to opening for any signs of

mishandling in transit or in storage, especially including tears, abrasions,

evidence of water damage. Report any observed damage to

support@twotouch.com

taking care to note the board's serial number (this is

displayed on an exterior label on the pack).

We strongly recommend that installers should in every case draw the

anticipated location of the IWB, projector, audio components, cabling and

faceplate on a diagram of the room layout, and that this must be validated

with the customer before the installation proceeds. Factors to be considered

include the following:

Impact of Light:

Be aware of the effect of bright light from windows (or artificial lights) on the

visibility of the projected image. As a general rule, place the IWB as far as

possible from windows, especially those facing west or north. In cases where

light effects are unavoidable, ensure that they can be controlled using blinds

and curtains.

Proximity to Heaters:

Be aware that heaters require clear air space for ventilation and heat

dispersion. The 2Touch IWB should not be mounted closer than 200mm

above a heater. Any other associated items (such as connection panels) must

be located no closer than 1m to heaters.

Proximity to Furniture:

Be aware that effective use of an IWB requires freedom of movement in front

of the IWB and on each side of it.

Specifically, users will need to be able to stand on either side of the IWB,

facing the class, and be able to touch the IWB with an outstretched arm,

Table of Contents