Additional Software Utilities - 2Touch 2150 series Installation Manual

• Concrete – wall mates + screws
• Timber / MDF - screws
NOTE: when applying fasteners to support projectors on the wall, be aware of
the substantial turning moment imposed by the cantilever of the projector.
This imposes a strong tensile load on the upper mount fastenings. Wallmates
(see left image in table below) do no suffice as they do not provide a
sufficient tensile fastening to support the cantilever moment from the
projector mount (they rely purely on the screw's bearing area under tension).
However, "Togglemates" or hollow wall anchors (see right images) are more
suitable and provide better tensile support as they both provide a toggle
which expands behind the wall to provide a larger and thus more effective
bearing area under tensile loads.
Wallmate
Additional cabling provisions
• USB cable extension (USB hub input to wall panel location)
• USB cable extension (if usb hub to be located on right side of IWB)
• USB A(male)-B(male) to supply hub within model 014 speakers (if
relevant)
• Calibration switch, twin core cable to extend, and connector block
Suggested Tools:
• Hand tools: Box cutter / stanley knife; wire cutters; pliers;
screwdrivers; allen key set.
• Electric drill & driver (with hammer function); set of drill bits including
concrete drill bit; array of driver bits and drill bits
• Soldering iron (to solder calibration switch)
• Consumables: insulation tape; canvas backed ("duct") tape; cable ties;
solder; Tek screws; connector / terminal blocks
• For rare on-site camera adjustments: 1.3mm allen key; Locktite; drill
bit (to drill out rivets)

Additional Software Utilities

An accredited 2Touch technician will use either USB_Settings or USBConfig
software utilities to ensure satisfactory performance after installation. The
process of using these tools to analyse and optimise the performance of the
Copyright 2Touch Technologies Limited 2007-2008. All rights reserved.
Hollow wall anchors