Installing The Epson Eb450 Projector With A 2Touch Iwb - 2Touch 2150 series Installation Manual

Installing the Epson EB450 Projector with a 2Touch IWB

1. Position bottom of bracket 40cm above top edge of whiteboard.
2. If image is to be placed at one edge of board, then projector bracket
centreline should be 950mm from that (outer) edge of board (see
diagram below).
3. Extend bracket to 37.5cm off wall position
4. Fit projector (remember to loosen cap screws permitting rotation
adjustment).
5. Press Num button; press 0, hold Num button down and press 0 four
times to unlock password protect on Epson projector.
6. Adjust to suit image on board – 40mm down from top of board.
a. Set Auto adjust = off
b. Set Resolution = auto
c. Set aspect = Full
d. Projector should adjust to keystone =0, medium zoom position.
Focus adjust is on slide in right hand compartment.
Copyright 2Touch Technologies Limited 2007-2008. All rights reserved.