2Touch 2150 series Installation Manual page 19

Additional or alternative snap-in modules may be supplied to
requirements from the following:
2T_MCS_blank
2T_MCS_RCA1/2/3 Modules with 1, 2 or 3 x RCA connectors
2T_MCS_USB
2T_MCS_RJ45
2T_MCS_Svideo
Through the combination of a choice of "snap-in"
faceplate modules, plus pre-terminated cabling
which connects to these using the supplied screws,
the installer's task of preparing and connecting the
faceplate is made extremely quick and simple.
The pre-terminated VGA cable is attached through
the front of the faceplate using the supplied screws
which in turn permit user cabling to be secured to
the front of the faceplate. Other pre-terminated
cabling (RCA and 3.5mm audio) are attached to
the ear of the faceplates using attached screws.
A large slide on one side of the connector box can be removed for easy side
access by cables or ducting. Additional holes are available through press-outs
in the plastic container both at rear and on sides.
Copyright 2Touch Technologies Limited 2007-2008. All rights reserved.
module - blank
module with USB-B on faceplate, USB-A behind
Module with RJ45 connector
Module with S-Video & 2x RCA connectors