Table of Contents
Advertisement
Final checks:
The following final checks should be performed on site for every board:
-
Camera signals are strong throughout (particularly observe signal
strength at and near opposing diagonal corner, and opposing camera);
-
each camera trace provides strong shadow depth throughout the
monitored range;
-
check opening and closing aperatures ;
-
check top straightening performance and adjust as required;
-
Calibration performs correctly;
-
Performance is accurate, responsive and comprehensive. Using
2Touch Workbook, rapidly draw dense lines on screen to ensure that
there are no "dead spots" and that responsiveness is good. Draw fast
tight circles all over the surface in a continuous stream (not "touch-
off"), to ensure that circles and curves are smooth and that there are
no gaps in line drawing.
-
One all above are checked satisfactory, save the board's configuration
file (.v299) and a snapshot of the camera traces showing camera
settings as well. These are both to be saved using the following file
name nomenclature:
SerialNumber_ReversedDateYYMMDD_location
For example: 123456_20101005_Pablo'sOffice
-
These files are to be uploaded by Dealer onto the board's record on
Tracker.
Copyright 2Touch Technologies Limited 2007-2008. All rights reserved.
Advertisement
Table of Contents
