Installing The 2Touch Modular Connection System (Mcs-1, Mcs-2) - 2Touch 2150 series Installation Manual

Installing the 2Touch Modular Connection System (MCS-1, MCS-2)

The 2Touch Modular Connection System (MCS) features
snap-in faceplate modules which can be selected to suit a
client's requirements, plus pre-terminated cabling which
simply screws into the rear of these modules to provide
connection outlets. The MCS is available from 2Touch in
two pre-configured packs:
• A single gang (MCS-1) providing for three snap-in
modules. By default the MCS-1 is supplied with
the following:
A. USB (type B) socket module;
B. Faceplate module offering VGA
socket plus 3.5mm audio socket;
C. Faceplate modules offering 1x, 2x
and 3x RCA;
D. 5m VGA cable with right-angle
fitting for wall panel end
E. 5m RCA video cable to suit
module
F. 3m 3.5mm audio cable to suit
module
G. Screws to fasten cable ends to
faceplate modules
• A dual-gang (MCS-2) providing for six snap-in modules. By default
the MCS-2 is supplied with the
following:
A. USB (type B) socket module;
B. 2 X Faceplate module offering
VGA socket plus 3.5mm audio
socket;
C. Faceplate modules offering 1x, 2x
and 3x RCA;
D. 5m VGA cable with right-angle
fitting for wall panel end
E. 5m RCA video cable to suit
module
F. 3m 3.5mm audio cable to suit module
G. 2 x 3m RCA audio cable
H. Screws to fasten cable ends to faceplate modules
Copyright 2Touch Technologies Limited 2007-2008. All rights reserved.