Before You Begin Programming Homelink - Dodge 2016 Viper Owner's Manual

124 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
HomeLink Buttons Sunvisor
NOTE: HomeLink is disabled when the Vehicle Security
Alarm is active.

Before You Begin Programming HomeLink

Ensure your vehicle is parked outside of the garage
before you begin programming.
For more efficient programming and accurate transmis-
sion of the radio-frequency signal it is recommended that
a new battery be placed in the hand-held transmitter of
the device that is being programmed to the HomeLink
system.
To erase the channels place the ignition in the ON/RUN
position and push and hold the two outside HomeLink
buttons (I and III) for up 20 seconds, or until the red
indicator flashes.
NOTE:
• Erasing all channels should only be performed when
programming HomeLink for the first time. Do not
erase channels when programming additional buttons.
• If you have any problems, or require assistance, please
call toll-free 800-355-3515 or, on the Internet at
HomeLink.com for information or assistance.