Before You Begin Programming Homelink; Programming A Rolling Code - Dodge Grand Caravan 2018 User Manual

HomeLink Buttons
NOTE:
HomeLink is disabled when the Vehicle Secu-
rity Alarm is active.
40

Before You Begin Programming HomeLink

Be sure that your vehicle is parked outside of
the garage before you begin programming.
For more efficient programming and accurate
transmission of the radio-frequency signal, it is
recommended that a new battery be placed in
the hand-held transmitter of the device that is
being programmed to the HomeLink system.
To erase the channels, place the ignition in the
ON/RUN position and push and hold the two
outside HomeLink buttons (I and III) for up
20 seconds or until the red indicator flashes.
NOTE:
• Erasing all channels should only be performed
when programming HomeLink for the first
time. Do not erase channels when program-
ming additional buttons.
• If you have any problems, or require assis-
tance, please call toll-free 1-800-355-3515
or, on the Internet at HomeLink.com for infor-
mation or assistance.

Programming A Rolling Code

For programming garage door openers that were
manufactured after 1995:
These garage door openers can be identified by
the "LEARN" or "TRAIN" button located where
the hanging antenna is attached to the garage
door opener. It is NOT the button that is nor-
mally used to open and close the door. The
name and color of the button may vary by
manufacturer.
1. Place the ignition in the ON/RUN position.
2. Place the hand-held transmitter 1 to
3 inches (3 to 8 cm) away from the
HomeLink button you wish to program while
keeping the HomeLink indicator light in
view.
3. Push and hold the HomeLink button you
want to program while you push and hold the
hand-held transmitter button.