Static Colors; Custom Color Mixing; Infrared Mode - Chauvet Freedom Par Quad-4 IP User Manual

Static Colors

Custom Color
Mixing

Infrared Mode

Freedom™ Par Quad-4 IP User Manual Rev. 1
To select a preset static color, do the following:
1. Press <MENU> repeatedly until C-- shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select the desired preset color (C 1–C 15).
4. Press <ENTER>.
To custom mix a color, follow the instructions below:
1. Press <MENU> repeatedly until U-- shows on the display.
2. Press <ENTER> and one of the following colors shows on the display: rXXX (red), gXXX (green),
bXXX (blue), or AXXX (amber).
3. Press <ENTER> repeatedly to select the desired color.
4. Use <UP> or <DOWN> to select the desired color value (0–255).
·
NOTE: Selecting 0 will turn the color off.
5. Press <ENTER> to select color value and continue to the next color.
6. Repeat steps 3 to 5 until you create your desired color.
Infrared (IR) mode allows the product to be controlled with an infrared remote controller. The
IRC-6 can remotely set the product to various modes; adjust the color, speed and sensitivity; and set the strobe.
The Freedom™ Par Quad-4 IP is compatible with the included IRC-6 from Chauvet. To enable use with the
IRC-6, follow the instructions below:
1. Press <MENU> repeatedly until SET shows on the display.
2. Press <ENTER> and ON (turns on the infrared sensor) or OFF (turns off the infrared sensor) shows
on the display.
3. Press <UP> or <DOWN> to select the desired option.
4. Press <ENTER>.
Page 17 of 22