Table of Contents
Advertisement
Operation
Static Operation
Auto Programs
Auto Test
Master/Slave
Software
Information
Temperature
Backlight
-10-
The Static mode allows the user to set the intensity and the strobe frequency from the
control panel without a DMX controller.
1. Go to the Static main level.
2. Select Dimmer.
3. Choose desired intensity (000–255).
4. Select Strobe.
5. Select the desired strobe frequency (000–255).
Auto programs allow for control of pre-programmed strobe looks without a DMX controller.
1. Go to the Auto Show main level.
2. Select the desired auto program (Auto 0–6).
3. Select Speed.
4. Choose the desired speed value (000–100).
You cannot edit any of the auto programs (Auto 0–6).
This option allows you to test all the LEDs on the STRIKE 4.
1. Go to Information main level.
2. Select Auto > Test.
The Master/Slave mode allows a group of STRIKE 4s (the slaves) to simultaneously
duplicate the output of another STRIKE 4 (the master) without a DMX controller.
1. Set each of the slaves:
a. Go to the Master/Slave Mode main level.
b. Select Slave.
2. Set the master product:
a. Go to the Master/Slave Mode main level.
b. Select Master.
c. Select an Auto program as explained in
explained in
Static
·
The master is the one that runs a program whether in Auto Show or Static
mode.
·
Do not connect a DMX controller to the products configured for Master/Slave
operation. The DMX controller may interfere with signals from the master
product.
·
The master should be the first product in the daisy chain.
This option shows what version of software the STRIKE 4 is running.
1. Go to the Information main level.
2. Select Version and the version number will show on the screen.
This option shows the internal temperature of each of the STRIKE 4's individual pods.
1. Go to the Temperature main level.
2. Select LED 1–4
This setting allows you to set the amount of time the backlight on the STRIKE 4 stays on
after the last button is pressed on the control panel.
1. Go to the Back Light main level.
2. Select On (remains on), 10 S (10 seconds), 20 S (20 seconds), or 30 S (30 seconds).
3. Press <ENTER>.
Auto Programs
Operation.
or Static program as
STRIKE 4 User Manual Rev. 1
Advertisement
Table of Contents
