Advertisement
Step 5: Add Wall Bracket
Slide the Wall Bracket Assembly down into place on the Pillar
(f).
Make sure the Wall Plate (g) fits into the channel in the Pillar as seen
in the Top View of Diagram 5. Once the Wall Bracket Assembly is in the desired position, tighten the M8 Allen Bolts (q) with an Allen
Key (nn) so the Wall Bracket Assembly is attached to the Pillar. Attach the Wall Bracket Spacers (h) to the Wall Bracket (b) by sliding
the Wall Bracket Spacers from the side so the plastic tabs into the correct oval holes on the Wall Bracket. See the Top View of Diagram
5. You may have to loosen the M8 Bolts in the Wall Bracket to have enough space to fit the Wall Bracket Spacers in between the Wall
Bracket and the Pillar.
Note: Make Sure The M8 Allen Bolts Are Tight!
Top View
Step 6: Add the Glass Shelf
Take the Glass Shelf Washer (k) and insert it onto the Glass Shelf (c). Make sure the holes in the Glass Shelf Washer and the Glass Shelf
are aligned. Slide the Glass Shelf assembly into the Shelf Bracket 0). Thread each 1/4-20 Allen Bolt (r) down through a Plastic Washer
(v), the Glass Shelf and into the Shelf Bracket assembly. Tighten the 1/4-20 Allen Bolts firmly so the Glass Shelf is secured to the Shelf
Bracket. See Detailed View A of Diagram 6 for assistance.
Add the Top Cap (m) to the top of the Pillar
(f)
by lining up the two plastic dowels on the bottom of the Top Cap with the corresponding
pattern on the top of the Pillar as seen in Detailed View B of Diagram 6. Press down firmly on the Top Cap to make sure it is in place.
Place the Shelf Bracket Cap
(I)
over the Shelf Bracket (j) so it hides the M8 Allen Bolt (q). See Detailed View A of Diagram 6 below.
Diagram 6
Detailed View B
Advertisement
