Advertisement
Step 1: Secure Pillar to Base
Attach the Pillar
(t)
to the Base (a) by placing each M12 x 40 Bolt (p) through an M12 Washer (w), each M8 x 35 Bolt
through an M8 Washer (t). Then thread each Bolt up through the Base and into the Pillar as shown in Diagram lao The M12
x
40 Bolts should be threaded into the front two holes of the Pillar, while the M8
x
35 Bolts should be threaded into the back
two holes of the Pillar. Tighten the M 12
x
40 Bolts with a wrench, and tighten the M8
x
35 Bolts with a Phillips screw driver.
Proceed to insert two M6
x
20 Bolts (n) into the holes on the back of the Pillar as seen in Diagram lb. Tighten the M6
x
20
Bolts with a Phillips screw driver.
Detailed View A
o
Diagram la
Step 2: Shelf Bracket Assembly
f
Detailed View B
a
Required Hardware for Step 1
(2) Ml2 x 40
(2) M8 x 35
~
(2) M6 x 20
.-B
(2)M12Washer
@
(2) M8 Washer
@
Thread an M8 Allen Bolt (q) through a Spring Washer (u), an M8 Washer (t), the Shelf Bracket 0), and into the Shelf Plate
(i). See Diagram 2 for the proper assembly of these parts. Loosely tighten the M8 Allen Bolt into the Shelf Plate with an
Allen Key (nn). Leave approximately a 118" gap between the Shelf Bracket and the Shelf Plate for Step 4.
Diagram 2
=
J
Required Hardware for Step 2
(2) M8 Allen Bolt
-=D
(2) Spring Washer
~
(2) M8 Washer
@
Advertisement
