Axminster Trade AT2001DP User Manual page 12

Assembly
Chuck guard
Locate the chuck guard assembly (6) and the three
Phillips screws. Offer up the fixing holes in the micro
switch unit with the three threaded holes to the side
of the drill head (1) and secure in place with the
Phillips screws, see figs 22-23
Fig 22-23
Thread holes
6
Plug the power connector into the micro switch unit,
unitl it clips home, see fig 24.
Fig 24
Phillips screw
Power connector
Morse taper arbor & chuck (Radial Drills Only)
Locate the morse taper arbor (10), insert the arbor
into the keyless chuck (9) then slot the assembly up
into the quill. Using a high faced mallet, lightly tap it
home. (see figs 25-26)
Bolt the pillar drill to the workbench or floor to secure
it in position.
12
Fig 25-26
10
9