Fig 17
caphead bolt, note the raised boss of the feed
mechanism and the two spigots inside the feed
handle. Mount the handle over the boss and ensure
the spigots inside the handle (7) engages into the
machined slot in the boss. Secure with the supplied
caphead bolt through the hole in the centre of the
handle through to the tapped hole in the mounting
boss (see figs 18-19-20-21).
Fig 18-19-20-21
Grub screw
Spigots
7
Threaded hole
Machined slot
Pulley cover knob
Locate the pulley cover knob (11), remove the Phillips
screw, insert the screw through the pre-drilled hole
in the pulley cover and secure the knob in place, see
fig 22.
11
Assembly
Raised boss
7
Fig 21
11
Continues Over...