Delete All Scenes - ADJ DMX OPERATOR 384 User Manual

DMX OPERATOR 384
Copy a Scene
(1)
Press and hold down the Program button for approximately 2 seconds or until the
PROG indicator in the LED-display flashes. Once the indicator is flashing, record
mode is engaged and you may release the Program button.
(2) Select the bank that contains the scene you want to copy with the Bank
UP/DOWN buttons.
(3)
Select the Scene # button, 1-8, that you want to copy.
(4)
Use the UP/DOWN BANK buttons to change the scene bank if desired.
(5)
Press the Midi/Rec button followed by the Scene # button, 1-8, that you want to
copy the scene to. All LED's should flash three times to confirm and save settings.
(6) Press and hold down the Program button for approximately 2 seconds or until the
PROG indicator in the LED-display stops flashing. A flashing Blackout indicator, in
the LED-display, is indicative that you are out of program mode.
Delete a Scene
(1) Press and hold down the Program button for approximately 2 seconds or until the
PROG indicator in the LED-display flashes. Once the indicator is flashing, record
mode is engaged and you may release the Program button.
(2) Select the bank that contains the scene you want to delete with the Bank
UP/DOWN buttons.
(3) Simultaneously, press the Auto/Del button then press the Scene # button, 1-8,
that you want to delete. All LED's should flash three times to confirm that the
scene was deleted.
(4) Repeat steps 2 & 3 to delete additional scenes.
(5)
Press and hold down the Program button for approximately 2 seconds or until the
PROG indicator in the LED-display stops flashing. A flashing Blackout indicator, in
the LED-display, is indicative that you are out of program mode.

Delete All Scenes

(1) Flip the Operators power switch OFF which is located at the rear of the unit.
(2) Simultaneously, press and hold down the Program and Bank Down buttons and
flip the power switch ON. All LED's will flash three times to confirm that all
scenes were deleted.
11