Appendix B Fault Codes - Teknique FWD Owner's Manual

Appendix B: Fault Codes
The microprocessor checks various features within the controller and will display
any fault indication. The controller may prevent the chair from driving if a critical
fault condition exists. Refer to the appropriate fault code section for the system
used on your Teknique.
Controllers with system status indicator
Tekniques with this controller system use a flashing "System Status Indicator" light
(located in the key symbol). When flashing, it indicates a "fault" condition some-
where in the control system (See Figure 11A, Page 54).
D82007778 REV O 6/10/14
When there is a fault please follow this procedure:
A. Switch off the control system.
B. Make sure that all connectors on the chair and the
control system are connected securely. Make sure
brake release levers are in the drive position.
C. Switch on the control system again and try to drive
the chair. If the fault occurs again, switch off and do
not try to use the wheelchair. Contact Hoveround
Support 1-800-96-HOVER (1-800-964-6837)
Chapter 11 53