Appendixes; Appendix A Programmable Parameters; Chapter 11 Appendixes - Teknique FWD Owner's Manual

Chapter 11

Appendixes

Appendix A:
Programmable Parameters
The controller used on your power wheelchair is programmable for basic functions.
It requires a programmer to make changes. Any changes must be made by a
qualified technician only.
The following chart indicates the standard program values of the factory settings.
Refer to the appropriate section depending on the style of control system on your
chair. Any subsequent change of the programmed values should be recorded and
saved for future reference.
Program Settings
Program Settings
Forward Speed Max
Forward Speed Min
Forward Acceleration
Forward Deceleration
Reverse Speed Max
Reverse Speed Min
Turning Speed Max
Turning Speed Min
Turning Acceleration
Turning Deceleration
52 Chapter 11
TEK FWD TEK RWD TEK XHD
VSI VR2 ALL VSI / VR2
85 75 100
10 20 10
30 20 30
50 65 50
55 50 55
10 20 10
15 15 20
10 10 10
10 10 30
20 70 20
TEK HD-6 TEK GT
VR2 Pilot+
85 70 100
10 10 25
30 30 20
50 50 50
50 50 55
10 20 10
15 15 25
10 10 25
20 20 5
20 50 5
D82007778 REV O 6/10/14
VR2
100
20
30
70
50
20
17
10
15
70