Arm Width Adjustment; Arm Height Adjustment - Teknique FWD Owner's Manual

Arm Width Adjustment

The standard seat has arm width adjustment (Figure 4F and 4G). To adjust the arm
width:
1. Locate the two knobs and two set screws on the square tube at the rear of
the seat.
2. Loosen the knobs and set screws.
3. Move the arms to a comfortable width. Make sure the tubes do not extend
beyond the set screws.
4. Tighten the knobs and set screws.

Arm Height Adjustment

If arm height adjustment is required an arm raising kit is available (Figure 4H) . To
adjust the arm height:
1. Locate the set screw on the back of the arm tube upright.
2. Loosen the screw and adjust the arm to a comfortable height.
3. Tighten the screw.
D82007778 REV O 6/10/14
Figure 4F
Figure 4H
Figure 4G
Chapter 4 31