Legrests - Teknique FWD Owner's Manual

Legrests

1. Install each legrest onto the appropriate hanger bracket and swing into the
forward facing position. If your chair has elevating legrests, set the angle to
the lowest position.
2. Fold down the foot plates. Your feet should comfortably rest on the plates
without a tendency to lift your thighs from the seat cushion.
3. If length adjustment is necessary, loosen the bolt at the base of one of the
legrest stems by two complete turns (1/2" wrench required). Tap the head of
the bolt to loosen the inner tube from the outer tube (See Figure 6B below).
4. Slide the lower (inner) tube within the upper (outer) tube to achieve the
correct legrest length. Tighten the bolt.
5. Repeat steps 3 and 4 for other legrest.
D82007778 REV O 6/10/14
Figure 6B - Legrest Adjustment
Chapter 6 39