Teknique FWD Owner's Manual page 25

• ONLY USE to charge AGM sealed lead acid batteries. Do
not attempt to charge any other type of battery or any
non-rechargeable type of battery.
• DO NOT attempt to use the charger as a DC power source
for any electrical or other equipment.
• DO NOT attempt to charge a frozen battery.
1. Select a clean, dry, cool, well ventilated area to use the charger.
2. If your charger is equipped with an on/off button, ensure that the charger is in
the OFF position, along with the joystick controller in the OFF position.
3. Connect the charger output cord into the charger port located on the front of
the joystick controller. Refer to Figure 2A below. Align the three pins on the
plug with the three holes on the port and push the plug in place. Make sure
the plug is fully seated in the charger port. If it is not pushed all the way, the
batteries will not charge or the plug may become hot.
D82007778 REV O 6/10/14
Figure 2A - Charger Port, Typical Location
Chapter 2 25