Lenovo ThinkCentre 3026 Maintenance Instructions Manual page 72

66
Hardware Maintenance Manual
Diagnostic Error Code
025-00X-XXX
025-01X-XXX
IDE interface failure
025-027-XXX
IDE interface Configuration/Setup error
025-02X-XXX
025-03X-XXX
025-04X-XXX
IDE Interface failure
025-195-XXX
IDE interface Test aborted by user
025-196-XXX
IDE interface test halt, error threshold
exceeded
025-197-XXX
IDE interface test warning
025-198-XXX
IDE interface test aborted
025-199-XXX
IDE interface test failed, cause unknown
030-000-XXX
SCSI interface Test Passed
030-00X-XXX
030-01X-XXX
SCSI interface failure
FRU/Action
1. IDE signal cable
2. Check power supply voltages
3. Reseat IDE signal cable
4. IDE device
5. System board
1. IDE signal cable
2. Flash the system. See "Updating
(flashing) BIOS from a disc" on page 326.
3. Reseat IDE signal cable
4. IDE device
5. System board
1. IDE signal cable
2. Check AC/DC power adapter
3. Reseat IDE signal cable
4. IDE device
5. System board
Information only
Restart the test, if necessary.
1. Press F3 to review the log file.
2. Restart the test to reset the log file.
1. Make sure the component that is called
out is connected and/or enabled. See .
2. Re-run the test.
3. Replace the component that is called out
in warning statement.
4. Replace the component under test.
1. If a component is called out, make sure it
is connected and/or enabled. See .
2. Flash the system and re-test. See
"Updating (flashing) BIOS from a disc"
on page 326.
3. Go to "Undetermined problems" on page
78.
1. Go to "Undetermined problems" on page
78.
2. Flash the system and re-test. See
"Updating (flashing) BIOS from a disc"
on page 326.
3. Replace component under function test.
No action
1. SCSI signal cable
2. Check AC/DC power adapter
3. SCSI device
4. SCSI adapter card, if installed
5. System board