Lenovo ThinkCentre 3026 Maintenance Instructions Manual page 109

9. To install a new hard disk drive into the blue bracket, flex the bracket and
Figure 21. Installing the hard disk drive into the bracket
10. Slide the new hard disk drive into the drive cage until it snaps into position.
11. Align the drive cage pivot pin with the slot 1 in the upper drive cage and
12. Connect the signal cable and the power cable to the new hard disk drive.
13. Press down on the metal latch 2 and pivot the drive cage into place, and
Figure 22. Installing the primary hard disk drive
Chapter 8. Replacing FRUs (Machine Types: 3029, 3054, 3139, 3219, 3246, 3282, 3349, 3421, 3544, 3652, 3769, 3934, 4992, 5206, 5267,
align pin 1 , pin 2 , pin 3 , and pin 4 on the bracket with the
corresponding holes in the hard disk drive. Do not touch the circuit board 5
on the bottom of the hard disk drive.
slide the hard disk drive cage into the chassis.
then slide it to the front of the computer until it snaps into position.
Note: There are two arrows, one on the upper drive cage and one on the hard
disk drive cage. The arrows are aligned when the hard disk drive is in the
proper position.
5325, 5384, 5450, 5474, 5498, 5554, 5852, 6232, and 6590.)
103