Nu-Vu RM-4T Owner's Manual page 17

RM/RA SERIES OWNER'S MANUAL
CAUTION: DO NOT USE ABRASIVE CLEANERS ON THE DOOR OR YOU
MAY SCRATCH THE GLASS!!!
• The Oven interior should be wiped out daily. Remove the Oven Element Cover once a
month for inspection and cleaning (if you have the INTERNAL STEAM option you should
remove, inspect and clean the element Cover weekly):
1) Remove the thumbscrews along the top edge and pull the Element Cover down.
2) Pull the Element Cover out through the front of the Oven.
• Inspect the Oven ceiling, the Blower Wheel, the Sidewalls and the Element Cover for
mineral deposits. Wipe these parts down with hot water and a mild soap, followed by a
rinse with clean fresh water and a mild sanitizing agent; wiping the interior dry will help
to prevent water spotting. Water spotting and any other mineral deposits should be
removed with any mild mineral removal agent as soon as they are noticeable.
• Replace the Oven Element Cover; make sure the small lip on the back of the Element
Cover slides into the support strip welded to the ceiling of the Oven and that the Element
Cover is pushed all the way back and up for a tight fit. Secure it in place with the
thumbscrews.
• The Oven Sidewalls should be removed on an as-needed basis for interior cleaning and
mineral removal. Replace them the same way as the Element Cover (small back lip in the
support strip, tight to the sides and all the way back).
EXTERIOR - -
• All exterior glass may be cleaned with any good glass-cleaning formula.
• The exterior metal surfaces can be cleaned with any good stainless steel cleaner or
polish, or with hot water and a mild soap followed by a thorough rinse with clean fresh
water if it is very soiled.
CAUTION: DO NOT ALLOW WATER NEAR THE CONTROL SURFACES!!!
* * * CAUTION * * *
NUVU® DOES NOT RECOMMEND the use of any strong commercial or caustic product on this
equipment. DO NOT allow any type of caustic cleaner to come into contact with any aluminum
parts (such as Door Frames), the silicon rubber Door Gaskets, or any of the sealant in the Oven
and Proofer seams and joints. These compounds may cause discoloration and degradation of these
parts resulting in permanent damage. DO NOT use bleach or bleach compounds on any chromed
parts; bleach may damage chrome plating.
NUVU®
(906) 863-4401 SALES FAX (906) 863-5889 • SERVICE FAX (906) 863-6322
MENOMINEE, MICHIGAN 49858
page 15