Start-Up - Nu-Vu RM-4T Owner's Manual

RM/RA SERIES OWNER'S MANUAL
unit positioning and service. Avoid any kinks or strains on the tubing and place the
tubing where it will not be damaged in any way.
B. The tubing end that attaches to the unit must not be damaged or deformed in any way.
The cut end should be cut straight and clean with no deforming of the tubing. All burrs
and sharp edges should be removed to ensure a proper fit and leak-free connection.
C. Position the tubing so that the tubing runs straight into the Water Intake Fitting. Be
careful not to kink the tubing if you bend it, and do not bend the tubing within two (2)
inches of the end.
D. The two-part compression fitting (tapered collar and nut) is placed approximately 1"
onto the tubing so that the collar is inside of the nut and the threaded opening of the nut is
toward the Water Intake Fitting.
E. Push the tubing all the way into the Water Intake Fitting (approximately ¼") and hold it
there while you thread the compression nut onto the Water Intake Fitting. Tighten the
compression nut with an open-end wrench. DO NOT OVER–TIGHTEN!!! If the joint
leaks when tested and further gentle tightening does not stop the leak the two-part
compression fitting must be replaced.
Careful attention to these simple procedures will help to ensure an installation without leaks. If you
have any questions or problems please call the NUVU® Service Department at (906) 863-4401.
IMPORTANT: THIS UNIT NEEDS TO BE INSTALLED WITH ADEQUATE
BACKFLOW PROTECTION TO COMPLY WITH APPLICABLE FEDERAL,
STATE AND LOCAL CODES.
IMPORTANT: THIS UNIT REQUIRES A SCREEN OF AT LEAST 100 MESH
TO BE INSTALLED IMMEDIATELY UPSTREAM OF ALL CHECK VALVE
TYPE BACKFLOW
PROTECTION. THE SCREEN SHALL BE ACCESSIBLE AND REMOVABLE
FOR CLEANING OR REPLACEMENT.
INITIAL START–UP
STANDARD OVEN:
A. Unscrew the glass Light Lenses in the rear of the Oven. Install the included Appliance
Bulbs (if they are not already installed) and replace the Lenses. Close the Oven
Door securely.
B. Engage the main electrical and optional water supplies.
C. Set the Oven Power Switch to ON. The interior of the Oven should illuminate and the
Oven Blower Wheel should begin to rotate.
D. Open the Oven Door. The Motor/Blower Wheel should come to a stop as the Door opens
and the Micro Switch in the Door Jamb is released.
E. Place a reliable oven thermometer on a baking pan in the center of the Oven.
NUVU®
(906) 863-4401
PREVENTERS
SALES FAX (906) 863-5889 • SERVICE FAX (906) 863-6322
USED FOR WATER
MENOMINEE, MICHIGAN 49858
SUPPLY
page 11