Turning The Power On/Off; Turning The Power On - Roland VC-50HD Owner's Manual

Turning the power on/off

Turning the power on

After you have made connections correctly, you must turn on the power as described below. Incorrect
operation may cause malfunctions or may damage the speakers of your monitoring system.
* Due to a circuitry-protection feature, the VC-50HD requires a few moments after it has been powered up
before it is ready for normal operation.
* If you are operating the unit only on AA batteries, the POWER indicator will blink when the batteries run
low. Replace the batteries as soon as possible.
On the side of the VC-50HD, slide the POWER switch in the direction of the arrow
and hold it for two or three seconds until the POWER indicator lights.
fig.POWER-sw.eps
If mode select switch 6 is on, so that remote control is activated, the VC-50HD's power will
automatically be turned on when power is supplied at DC IN. In this case, the POWER switch is
disabled. However, the power will not turn on automatically if you're using only the internal AA
batteries as the power supply, with nothing connected to the DC IN connector. Use the POWER
switch to turn the power on/off.
Mode select switch 6 is the remote control setting. For details on remote control, refer to "Accepting
remote control" (p. 28).
20