Using The Vc-50Hd With The F-1 - Roland VC-50HD Owner's Manual

Using the VC-50HD with the F-1

If the VC-50HD is used with the F-1 (version 2 or later), the output from an SDI device can be captured
by the F-1, or be sent from the F-1 to an SDI device.
fig.VCandF1.eps
To use the VC-50HD in conjunction with the F-1, make the following setting.
fig.PC-remote.eps
For details about settings on the F-1, refer to the F-1 Version 2 owner's manual section "Using the F-1
with the VC-50HD."
If mode select switch 6 is turned ON so that remote control will be received, operation of the
other switches will be disabled.
Even if the VC-50HD is set to receive remote control, the power will not turn on automatically if
you're using only the internal AA batteries as the power supply, with nothing connected to the
DC IN connector. Use the POWER switch to turn the power on/off.
Even if the VC-50HD is set to receive remote control, the power will not turn on automatically if
you're using only the internal AA batteries as the power supply, with nothing connected to the
DC IN connector. Use the POWER switch to turn the power on/off.
ON
Connections with video devices
25