Sony PDW-HD1500 Operation Manual page 88

To cue up the In point or Out point
Display the Thumbnail Menu, select Cue up Inpoint or
Cue up Outpoint, and then press the PUSH
SET(S.SEL) knob.
To cancel the In point or Out point setting
Display the Thumbnail Menu, select Reset Inpoint or
Reset Outpoint, and then press the PUSH SET(S.SEL)
knob.
The In point or Out point setting returns to the previous
value.
6
Select OK, and then press the PUSH SET(S.SEL)
knob.
7
Repeat steps 1 to 6 as required.
8
Save the clip list (see page 89).
To delete sub clips
See page 72 for more information about thumbnail screen
operations.
1
Select the clips to delete in the clip list thumbnail
screen (multiple selections possible).
2
Display the Thumbnail Menu.
3
Select Delete Sub Clips, and then press the PUSH
SET(S.SEL) knob.
A message appears asking you to confirm the deletion.
4
Select OK, and then press the PUSH SET(S.SEL)
knob.
5
Repeat steps 1 to 4 as required.
6
Save the clip list (see page 89).
To play the clip list
Note
When this unit is in single clip playback mode (see
page 60), only the selected sub clip can be played.
See page 72 for more information about GUI screen
operations.
To play using GUI screens
1
In the clip list thumbnail screen, select the thumbnail
of the sub clip where you want to start play.
88
Scene Selection (Clip List Editing)
To start play from the start of the clip list
Select the thumbnail of the first sub clip.
2
Press the PUSH SET(S.SEL) knob.
To play using the clip list playback screen
1
Display the clip list playback screen.
2
Press the PREV button or the NEXT button to display
the sub clip that you want to play.
To start play from the first sub clip
Press the SHIFT + PREV buttons to move to the start
of the clip list.
3
Press the PUSH SET(S.SEL) knob.
To change the starting timecode of clip
lists
The timecode of clip lists is continuous timecode,
unrelated to the timecode of the original clips. By default
the timecode (LTC) of the start of the clip list is
00:00:00:00, but it can be set to any value.
See page 72 for more information about thumbnail screen
operations.
1
In the clip list thumbnail screen, display the
Thumbnail Menu.
2
Select Set Start Time Code, and then press the PUSH
SET(S.SEL) knob.
The Set Start Time Code screen appears.
Set Start Time Code
TC 2 2 : 3 4 . 5 6 : 1 7
H M I N
Preset TC 00:00:00:00
3
Press the B/IN or b/OUT button to select the digit that
you want to change.
4
Turn the PUSH SET(S.SEL) knob or the jog dial to
change the value of the digit.
5
Repeat steps 3 and 4 as required.
S E C F R M
OK
Cancel