Command List - Sony PDW-HD1500 Operation Manual

Note
An FTP client that supports UTF-8 is required to use
Unicode characters other than ASCII characters.
Command prompt FTP commands do not support UTF-8.
To log in
If this unit is connected to a remote computer with a FAM
connection, first exit file operations on the FAM
connection (see page 111).
1
Load a disc into this unit and put the unit into the
following state.
• Recording, playback, search and other disc
operations (see page 50): Stopped
• THUMBNAIL button (see page 18): Off
• Disc access by Lock or Delete All Clips, Format
Disc, and so on in the Disc Menu (see page 71):
Stopped
• Connections between this unit and a computer by the
Live Logging function: Disconnected
• Setting of setup menu item 258 LIVE LOGGING:
Values other than "live view mode" ("off" or "live
mode")
Note
Login is not possible unless a disc is loaded and the
unit is in the state described above.
2
Start the command prompt.
3
Enter "ftp <SP> <IP address>", and press the Enter
key. (<SP> refers to a space.)
For example, if the IP address of this unit is set to
"192.168.001.010", enter "ftp 192.168.1.10".
Refer to the Windows help for more information about
the FTP command.
If the connection succeeds, you are prompted to enter
a user name.
4
Enter the user name "admin" and press the Enter key.
When the user name is verified, you are prompted to
enter a password.
5
Enter the password and press the Enter key.
The password is set to the model name ("pdw-f1600"
or "pdw-hd1500") when the unit is shipped from the
factory.
The login is complete when the password is verified.
See page 114 for the FTP protocol commands
supported by this unit.
114
FTP File Operations
If the connection times out
This unit terminates FTP connections if no command
is received within 90 seconds of the last command. If
this occurs, log out (see the next section) and repeat
steps 2 to 4.
Note
If you power this unit off during an FTP connection,
the data transferred thus far is discarded.
To log out
To log out after finishing file operations, enter "QUIT" at
the command prompt and press the Enter key.

Command list

The FTP protocol commands supported by this unit
include standard commands (see the next section) and
extended commands (see page 117).
Notes
• To execute FTP commands, you must install application
software with FTP function on your computer.
• The commands supported by application software vary.
• An FTP client that supports UTF-8 is required to use
Unicode characters other than ASCII characters.
Command prompt FTP commands do not support
UTF-8.
Standard commands
In the command syntax, <SP> means a space, entered by
pressing the space bar, and <CRLF> means a new line,
entered by pressing the Enter key.
USER
Send this command to begin the login process.
Command syntax: USER <SP> <user name> <CRLF>
Input example: USER admin
PASS
After sending the USER command, send this command to
complete the login process.
Command syntax: PASS <SP> <password> <CRLF>
Input example: PASS pdw-hd1500
QUIT
Terminates the FTP connection. If a file is being
transferred, terminates after completion of the transfer.
Command syntax: QUIT <CRLF>