Sony PDW-HD1500 Operation Manual page 167

Alarm message in time Alarm message in video monitor screen Action
data display area
REF NON-STD A NON-STANDARD REF SIGNAL IS
BEING USED FOR REF VIDEO. USE A
STANDARD SIGNAL.
a) Displayed only when setup menu item 016 ALARM DISPLAY is set to
"on".
Alarms relating to sensors and drives
Alarm message in time Alarm message in video monitor screen Action
data display area
FAN Stopped FAN MOTOR STOPPED.
DR-FAN Stop DRIVE FAN MOTOR STOPPED.
N-FAN Stop FAN MOTOR ON NET-4 BOARD
STOPPED.
High TEMP! HIGH TEMPERATURE.
HIGH TEMPERATURE IN DRIVE.
HIGH TEMPERATURE ON NET-4 BOARD.
HUMID!
BATT EMPTY!
Unknown USB UNKNOWN USB DEVICE.
Alarms related to system frequency and recording format
The following alarms are displayed only when setup menu
item 016 ALARM DISPLAY is set to "on" or "limit".
Alarm message in time Alarm message in video monitor screen Action
data display area
1080/59.94i RECORDING AND PLAYBACK IS NOT
POSSIBLE.
1080/29.97P
SYSTEM SETTINGS DIFFERENT FROM
1080/50i DISC.
1080/25P
1080/23.98P
720/59.94P
720/50P
525/59.94i
625/50i
1080/59.94i DISC CANNOT BE RECORDED.
VIDEO RESOLUTION DIFFER FROM IT
1080/50i
ON DISC.
1080/29.97P
1080/25P
1080/23.98P
720/59.94P
720/50P
MOISTURE HAS BEEN DETECTED.
BATTERY EMPTY!
Input a standard signal.
Contact your Sony service representative.
Note
The unit will not stop operating, but if you continue to
use it in this state temperatures inside the unit or the
drive will rise, possibly resulting in failure or fire.
Stop recording or playback, power the unit off and on
again, and wait until the HUMID display disappears.
Change the battery.
The USB connector of this unit is for maintenance
purposes and connection of USB devices. Connect a
compatible USB device.
This appears when the system frequency of the unit
differs from that of the loaded disc. Insert a disc with
the same system frequency as the unit, or change the
unit's system frequency.
This appears when mixed format recording mode is
disabled and the current system lines setting of this
unit does not match the resolution of the inserted
disc.
Insert a disc with a resolution that matches the
current system lines setting of this unit, or change the
system lines setting of this unit, or enable mixed
format recording mode.
167
Troubleshooting