Replacing An Internal Sd Card - Cisco UCS C220 M4 Installation And Service Manual

Installing or Replacing Server Components

Replacing an Internal SD Card

The server has two internal SD card bays on the motherboard.
Dual SD cards are supported. RAID 1 support can be configured through the Cisco IMC interface.
Remove the SD card that you are replacing:
Step 1
a.
b.
If you cannot safely view and access the component, remove the server from the rack.
Caution
c.
d.
e.
f.
Install an SD card:
Step 2
a.
b.
c.
Step 3 Replace the server in the rack, replace cables, and then power on the server by pressing the Power button.
Figure 3-16
1
Cisco UCS C220 M4 Server Installation and Service Guide
3-26
Power off the server as described in
Slide the server out the front of the rack far enough so that you can remove the top cover. You might
have to detach cables from the rear panel to provide clearance.
Remove the top cover as described in
Locate the SD card that you are replacing on the motherboard (see
Push on the top of the SD card, and then release it to allow it to spring up in the slot.
Remove the SD card from the slot.
Insert the SD card into the slot with the label side facing up.
Press on the top of the card until it clicks in the slot and stays in place.
Replace the top cover.
SD Card Bays and USB Port Locations on the Motherboard
FAN 6
FAN 5
FAN 4
FAN 3
FAN 2
FAN 1
SD card bays SD1 and SD2
Shutting Down and Powering Off the Server, page
Removing and Replacing the Server Top Cover, page
1 2
PSU 2
SD 1
PSU 1
CPU 2
SD 2
PCIe Riser 2
PCIe Riser 1
CPU 1
2 USB 3.0 port
Chapter 3 Maintaining the Server
3-7.
3-8.
Figure 3-16).
OL-32473-01