Replacing An Internal Sd Card - Cisco UCS C240 M4 Installation And Service Manual

Chapter 3 Maintaining the Server

Replacing an Internal SD Card

The server has two internal SD card bays on the motherboard.
Dual SD cards are supported. RAID 1 support can be configured through the Cisco IMC interface.
Step 1 Slide the server out the front of the rack far enough so that you can remove the top cover. You might have
to detach cables from the rear panel to provide clearance.
If you cannot safely view and access the component, remove the server from the rack.
Caution
Remove the top cover as described in
Step 2
Remove an SD card (see
Step 3
a.
b.
Step 4 Install an SD card:
a.
b.
Step 5 Replace the top cover.
Step 6 Replace the server in the rack.
Figure 3-23
1
OL-32474-01
Figure
Push on the top of the SD card, and then release it to allow it to spring out from the slot.
Remove the SD card from the slot.
Insert the SD card into the slot with the label side facing up.
Press on the top of the card until it clicks in the slot and stays in place.
SD Card Bay Location and Numbering on the Motherboard
SD card bays SD1 and SD2
Removing and Replacing the Server Top Cover, page
3-23).
1
Riser 2
Riser 1
Cisco UCS C240 M4 Server Installation and Service Guide
Replacing an Internal SD Card
3-10.
3-39