Disabling The Embedded Raid Controller In The Bios; Launching The Lsi Embedded Raid Configuration Utility - Cisco UCS C220 M4 Installation And Service Manual

Appendix C RAID Controller Considerations

Disabling the Embedded RAID Controller in the BIOS

Boot the server and press F2 when prompted to enter the BIOS Setup Utility.
Step 1
Select the Advanced tab, and then select LOM and PCIe Slots Configuration.
Step 2
Set PCH SATA Mode to Disabled.
Step 3
Press F10 to save your changes and exit the utility.
Step 4

Launching the LSI Embedded RAID Configuration Utility

Launch the LSI utility by pressing Ctrl-M when you see the prompt during system boot.
For information about using the Embedded MegaRAID software to configure your disk arrays, see the
LSI Embedded MegaRAID Software User
OL-32473-01
Guide.
Cisco UCS C220 M4 Server Installation and Service Guide
Embedded SATA RAID Controllers
C-15