Enabling Tpm Support In The Bios - Cisco UCS C220 M4 Installation And Service Manual

Installing or Replacing Server Components
Figure 3-27
1

Enabling TPM Support in the BIOS

After hardware installation, you must enable TPM support in the BIOS:
Note
Enable TPM support:
Step 1
a.
b.
c.
d.
e.
f.
Verify that TPM support is now enabled:
Step 2
a.
b.
c.
d.
e.
Continue with
Step 3
Cisco UCS C220 M4 Server Installation and Service Guide
3-46
TPM Socket Location on Motherboard
FAN 6
FAN 5
FAN 4
FAN 3
FAN 2
FAN 1
TPM socket and screw hole on motherboard
Watch during bootup for the F2 prompt, and then press F2 to enter BIOS setup.
Log in to the BIOS Setup Utility with your BIOS Administrator password.
On the BIOS Setup Utility window, choose the Advanced tab.
Choose Trusted Computing to open the TPM Security Device Configuration window.
Change TPM SUPPORT to Enabled.
Press F10 to save your settings and reboot the server.
Watch during bootup for the F2 prompt, and then press F2 to enter BIOS setup.
Log into the BIOS Setup utility with your BIOS Administrator password.
Choose the Advanced tab.
Choose Trusted Computing to open the TPM Security Device Configuration window.
Verify that TPM SUPPORT and TPM State are Enabled.
Enabling the Intel TXT Feature in the BIOS, page
PSU 2
SD 1
PSU 1
CPU 2
SD 2
PCIe Riser 2
PCIe Riser 1
CPU 1
3-47.
Chapter 3 Maintaining the Server
1
OL-32473-01