Displaying Peaking; Displaying Zebra; Obtaining Location Information (Gps) - Sony PXW-FS7 Operating Instructions Manual

Note
The B/T and ROT view are displayed in the viewfinder
only. The output video and recorded video remain
unaffected.

Displaying Peaking

You can turn peaking on/off by pressing the
PEAKING button on the viewfinder (page 11).
You can turn peaking on/off and set the peaking
type and peaking frequency using Peaking
(page 78) in the VF menu.
Note
Cannot be used when Picture Cache Rec mode is on.

Displaying Zebra

You can turn zebra pattern display on/off by
pressing the ZEBRA button on the viewfinder
(page 11).
You can turn zebra pattern display on/off, and set
the zebra pattern type and display level using
Zebra (page 78) in the VF menu.
Note
Cannot be used when Picture Cache Rec mode is on.
Obtaining Location Information
(GPS)
Set GPS to "On" in the System menu.
is displayed when the camcorder is seeking
GPS satellites. When positioning is established,
location information is recorded when shooting
video.
Notes
• The GPS setting in the System menu cannot be set to
"On" when the handle is not attached, as the GPS
receiver is built into the handle.
• The icon displayed varies, depending on the signal
reception from the GPS satellites.
Positioning Display
status
Off No display
Positioning
not available
Searching for
satellites
Positioning
• GPS is set to "On" by factory default. Location and
time information of video shot when positioning is
enabled is recorded by the camcorder.
• If a positioning icon is not displayed after several
minutes, there may be a problem with signal reception.
Start shooting without location information, or move
to an area with a clear view of the sky. Shooting when
a positioning icon is not displayed means that location
information will not be recorded.
• The GPS signal may not be received when indoors or
near tall structures. Move to a location with a clear
view of the sky.
• The recording of location information may be
interrupted, depending on the strength of the received
signal, even if a positioning icon is displayed.
49
GPS reception state
GPS is set to "Off" or an
error occurred.
Location information
could not be obtained
because GPS signal could
not be received. Move to
a location with a clear
view of the sky.
Searching for GPS
satellites. Several
minutes may be required
to acquire satellites.
A weak GPS signal is
being received.
A GPS signal is being
received. Location
information can be
acquired.
A strong GPS signal is
being received. Location
information can be
acquired.