Filter Types And Nat; Firewall Versus Filters; Figure 289 Protocol And Device Filter Sets - ZyXEL Communications ZyWALL 5 User Manual

ZyWALL 5 User's Guide
M = N means an action can be taken immediately. The action is to drop the packet (m = D) if
the action is matched and to forward the packet immediately (n = F) if the action is not
matched no matter whether there are more rules to be checked (there aren't in this example).
After you've created the filter set, you must apply it.
1 Enter 11 from the main menu to go to menu 11.
2 enter 1 to open Menu 11.1 - Remote Node Profile.
3 Go to the Edit Filter Sets field, press [SPACE BAR] to select Yes and press [ENTER].
4 This brings you to menu 11.1.4. Apply a filter set (our example filter set 3) as shown in
Figure
5 Press [ENTER] to confirm after you enter the set numbers and to leave menu 11.1.4.

35.4 Filter Types and NAT

There are two classes of filter rules, Generic Filter (Device) rules and protocol filter (TCP/
IP) rules. Generic filter rules act on the raw data from/to LAN and WAN. Protocol filter rules
act on the IP packets. Generic and TCP/IP filter rules are discussed in more detail in the next
section. When NAT (Network Address Translation) is enabled, the inside IP address and port
number are replaced on a connection-by-connection basis, which makes it impossible to know
the exact address and port on the wire. Therefore, the ZyWALL applies the protocol filters to
the "native" IP address and port number before NAT for outgoing packets and after NAT for
incoming packets. On the other hand, the generic, or device filters are applied to the raw
packets that appear on the wire. They are applied at the point when the ZyWALL is receiving
and sending the packets; i.e. the interface. The interface can be an Ethernet port or any other
hardware port. The following diagram illustrates this.

Figure 289 Protocol and Device Filter Sets

35.5 Firewall Versus Filters

Firewall configuration is discussed in
made between filtering, NAT and the firewall.
474
292.
Chapter 10 on page 163. Further comparisons are also
Chapter 35 Filter Configuration