Resynchronization: Configuration File Checking; Vcs754 Restart - VTech VCS754 Administrator And Provisioning Manual

Resynchronization: configuration file checking

You can select a number of options that determine when the VCS754 checks for new
configuration files. This process of checking for configuration files is called
Resynchronization. Resynchronization options are available on the WebUI Provisioning
page, but you can also include them in a configuration file.
The resynchronization options are:
 Mode—sets the VCS754 to check for a configuration file only, a firmware update
file only, or both types of file.
 Never—configuration file checking is disabled
 Bootup—the VCS754 checks for new configuration files when it boots up. Any
updates are applied during the boot-up process.
 Remote check-sync—enables you to start a resynchronization remotely using your
hosted server's web portal. The Remote check-sync settings are available only in
the configuration file, not the WebUI.
 Repeatedly, at a defined interval from 60 to 65535 minutes (45 days).

VCS754 restart

If the VCS754 needs to restart after an auto-update, the restart happens only after the
device has been idle for one minute.
To prevent users from delaying the update process (auto-updates cannot begin until the
VCS754 has been idle for one minute), or to avoid device restarts that might interfere with
incoming calls:
 set the resynchronization interval to a suitable period
 upload any new configuration file(s) to your provisioning server after work hours so
that the VCS754 will download the file(s) when there is no call activity.
When you update the VCS754 by importing a configuration file using the WebUI, the device
restarts immediately after applying the new settings, regardless of whether the VCS754 is
idle.
Provisioning Using Configuration Files
VCS754 Administrator and Provisioning Manual
78
Back to Contents