VTech VCS754 Administrator And Provisioning Manual page 21

To enable or disable DHCP:
1. From the Network setting menu, press
SELECT.
The DHCP screen appears.
2. Press
DHCP is enabled by default, which means the VCS754 will get its IP address from the
network. When DHCP is disabled, you must enter a static IP address for the VCS754.
To set static IP for the VCS754:
1. From the Network setting menu, press
press SELECT.
If DHCP is disabled, the Set static IP menu appears. If DHCP is enabled, an error
message appears briefly before returning you to the Network setting menu.
2. On the Set static IP menu, enter the static IP address. Use the dial pad and the
Add dot
3. Press
enter characters. Press
4. Press
characters. Press
5. Press .
Configuration Using the Phone Menus
 
to select Enabled or Disabled, and then press
or
You must be familiar with TCP/IP principles and protocols to configure static IP
settings.
soft key to enter characters. Press

and enter the Subnet Mask. Use the dial pad and the
 
or

and enter the Gateway. Use the dial pad and the Add dot soft key to enter
 
or to advance to the next character.
VCS754 Administrator and Provisioning Manual
 
to highlight DHCP, and then press
or
 
to highlight Set static IP, and then
or
 
or to advance to the next character.
to advance to the next character.
21
Save .
Add dot soft key to
Back to Contents