Cec Cage; Removal; Replacement - IBM 6C1 Service Manual

CEC Cage

The following procedures cover removal and replacement of the CEC cage.

Removal

1. If you have not already done so, shut down the system as described in "Stopping
the System" on page 254.
2. If you have not already done so, unplug the system power cables from the electrical
outlets.
3. If your system is a Model 6C1 (rack mount), place the system in the service position
as described in "Placing the Model 6C1 in the Service Position" on page 255.
4. If you have not already done so, remove the service access cover as described in
"Covers" on page 258.
5. Remove the processor and memory card cover as described in "Processor and
Memory Card Cover" on page 264.
6. Remove the processor cards as described in "Processor Card" on page 273.
7. Remove the memory card as described in "Memory Card and Memory DIMMs" on
page 266.
8. Remove the screws (6) and remove the CEC cage from the system board.

Replacement

Replace in reverse order.
Chapter 9. Removal and Replacement Procedures
265