IBM 6C1 Service Manual page 251

Set Address
Client Addr
Server Addr
Gateway Addr
Subnet Mask
Save
If any of the addresses is incomplete or contains a number other than 0 to 255, an error
message displays when you select the Save icon. To clear this error, correct the
address and select Save again.
Attention: If the client system and the server are on the same subnet, set the
gateway IP address to [0.0.0.0].
To change an address, press the backspace key on the highlighted address until the
old address is completely deleted. Then type the new address.
The Set Address icon allows you to define addresses
from which your system unit can receive RIPL code.
Remote IPL Setup
000.000.000.000
000.000.000.000
000.000.000.000
255.255.255.000
Chapter 8. Using System Management Services
Exit
233