Quick Install; Connections - Bosch DIVAR AN 3000 Installation Manual

10 en | Quick install
3

Quick install

To get the unit operational, perform the following quick install steps:
1.
2.
3.
4.
After completing this initial setup, the system is ready to run and will show a live view of the
camera image(s). If required, you can alter the settings later using the menus and/or factory
defaults, or you can run the Startup wizard again.
3.1

Connections

Connections on back of DIVAR AN 3000
Notice!
The 4- and 8-channel DIVAR AN 3000
2015.03 | v2.2 | AM18-Q0668
Make all the hardware connections – see Connections, page 10.
Power up the system – see Powering up, page 13.
Log in – see Login, page 14.
Correctly configure your system software with the Startup wizard (this appears the first
time the unit is started) – see Startup Wizard, page 15.
2 4 6 8 10 12
1 3 5 7 9 11
1 Camera VIDEO IN BNC connectors
2 CVBS output - Monitor A
3 Audio inputs
4 Audio output
5 Alarm inputs
6 RS232 connector for Dome control
7 Power ON/OFF switch
8 12 VDC Power connector
14 16 CVBS MON. A
AUDIO OUT
2 4
1
3
MIC IN
13 15 CVBS MON. B
AUDIO IN
10 VGA output - Monitor A
11 HDMI output - Monitor A
12 USB connector
13 RS485 connector for Dome control
14 Alarm outputs
15 Microphone input
16 CVBS output - Monitor B
Installation Manual
DIVAR AN 3000 / DIVAR AN 5000
5 6 7 8 9 10 11 12 13 14 15 16
ALARM IN
+ _
G
G
VGA MON.A
ALARM OUT RS-485
HDMI MON.A
9 RJ45 ethernet connector
Bosch Security Systems
ON
OFF
0
- +
RS-232
12VDC
ETHERNET