Quick Install; Primary Connections; Optional Connections; Quick Install Menu - Bosch DVR 440 Quick Install Manual

Video Recorder 400 Series

Quick install

To get the unit quickly operational, make the connections
described below and then enter the relevant data in the
Quick install menu. The Quick install menu appears the first
time the unit is started.
Connections

Primary connections

1. Connect the cameras to the VIDEO IN BNC connectors.
2. Connect monitor A to the VGA MON A output
(supporting 800x600, 1024x768, or 1280x1024).
3. Connect a USB mouse to the USB port.

Optional connections

1. Connect monitor B to the C MON B BNC connector.
2. Connect an audio signal to the AUDIO IN RCA (CINCH)
input.
3. Connect the AUDIO OUT RCA (CINCH) output to the
monitor or an audio amplifier.
4. Connect up to 4/8 alarms to the ALARM IN inputs (via
the supplied terminal blocks).
5. Connect the ALARM OUT output (via the supplied
terminal blocks).
6. Connect a pan/tilt/zoom control unit to the RS-485 port
(via the supplied terminal block).
7. Connect to your network via the RJ-45 Ethernet port.
8. Connect a "Bosch RS232 to Bi-phase converter" to the
RS-232 port if required.
Powering up
Switch on all connected equipment.
– Connect the power unit to the AC power outlet.
– Connect the DC power cord to the 12VDC connector on
the unit.
First-time use
The Quick install menu opens the first time the unit is used.
Fill in the basic settings in the three tabs to get the unit
operational. The unit begins recording automatically when
the Quick install menu is closed.
Bosch Security Systems
To open the Quick install menu at any other time:
1. Press the menu key to bring up the System Control
Bar.
2. Press the menu key again to enter the main menu.
– The main menu appears on monitor A.
3. Select System, then the Configuration submenu, and
finally Quick install.
Navigating
Use a USB mouse or the following front panel keys:
– Use the enter key to select a submenu or item.
– Use the arrow
move through a menu or list.
– Use the exit key to go back or to switch off the
menu.
After bootup, the unit shows the log-in screen over a quad
display. The default User ID is ADMINISTRATOR, the default
password is 000000 (six zeros).

Quick install menu

The Quick install menu contains three tabs: International,
Continuous Recording, and Network. Click the Exit button to
exit the Quick install menu. Changing Quick install settings
overwrites customized settings.
International
Language Select the language for the menu from the list.
Time zone Select a time zone from the list.
Time Select either a 12 or a 24 hour clock format.
format
Time Fill in the current time.
Date Select from three date formats which show
format either the month (MM), the day (DD), or the
year (YYYY) first.
Date Fill in the current date.
Continuous Recording
Set the Continuous Recording Resolution, Quality, Frame
rate, Covert, and Audio for each profile in the table.
Network
Fill in the settings that control the behavior of the unit with
respect to a network.
keys to
DVR name Enter a unique DVR name to be used in the
network.
DHCP Enable DHCP to have IP address, subnet
mask, and default gateway assigned
automatically by the network server.
The actual values are displayed.
IP address, Fill in the IP, subnet mask, gateway
Subnet mask, addresses, and DNS server addresses
and Gateway when DHCP is not enabled.
Quick install | en 4
v1.0 | 2011.08