Testing The Bike - Matrix R5X-05 Service Manual

9.24 TESTING THE BIKE

ONCE THE UNIT OR REPLACEMENT PART IS FULLY INSTALLED AND ASSEMBLED AND
PROPERLY PLACED ON THE FLOOR, USE THE FOLLOWING INSTRUCTIONS TO SETUP
1) Check that the console is set for recumbent bike.
a. Press and hold both LEVEL keys until Manager Mode appears on the display.
b. Press the UP or DOWN LEVEL keys until Engineering Mode appears on the display.
c. Use the UP or DOWN LEVEL keys to scroll to Machine Type.
d. Press ENTER on Machine Type and make sure it is set for R5x-05.
e. If Machine Type is not set for R5x-05, change to R5x-05 using the UP or DOWN LEVEL key and press ENTER to save.
f. Press and hold the STOP key for 3-5 seconds to return to normal function.
2) If the unit has an add on TV, program the TV channels (see Entertainment Owner's Manual).
3) If the unit is a installed as part of a new installation or if a battery was replaced, charge the battery.
4) Without hitting start or entering any program modes, sit on the bike and hold the handlebars while pedaling to simulate exercising. While
moving, listen for any odd noises or squeaks.
5) After stopping movement, press the green GO key and begin pedaling.
6) Grasp the hand grips to check for proper heart rate response.
7) Press the level up and down buttons on the console and hand grips to make sure resistance is fully functional.
8) Move the seat forward and back to check for excessive play or difficulty moving the seat.
9) If everything functions properly, stop pedaling and the unit will reset to normal operation within 30 seconds.
58
CHAPTER 9: PART REPLACEMENT GUIDE
AND TEST THE MACHINE: